Armorol Nano lubricant

Armorol nano lubricant is an engine oil additive which can be used in car and motor cycle engines to reduce the friction up to 400% . This has some additional benefits too.

The reason why oil lasts so long is because of the presence of nano particles of the size in 50nm which coats the engine surface permanently and increase the hardness of the metal thus increasing wear resistance .Because of this, it reduces friction by 4 times and do engine oil temperature can’t go more than 65 degrees even in air cooled enginesSince the oil remains cooler, oil additive chemicals won’t break down and enhances the drain interval more than even synthetic oil can provide .

50nm is the size of HIV virus , It can be used one time or can be repeated for every oil change . Advantage of using nano lube along with engine oil is it significantly increases engine oil drain internal and eliminates engine maintenance . Nano lube can be mixed in engine oil, gear oil, air compressor oil in thick grease and can be used to lube motorcycle chain as well(with drained engine oil containing nano lube). This way nothing will be wasted.

You can expect changes to appear after 5 to 10kmBut actual performance of nano lube will start to be visible after 3000kms . Regularly cleaning the chain and lubing chain can make the chain last for 60000kms even if driving is harsh . Ordinary oils will lose its lubrication qualities at 3000kms and nano lube will keep on improving performance even after 3000kms .

Engine oil remains cooler and emissions reduces as well .There is not enough words to describe it .You have to use it to believe it . Most notable change is you will have to apply noticeably less throttle to reach same speed and one more thing is if you drive in mountain areas then you have to be careful because engine braking will be dangerously low .

If dose is exceeded in wet clutch motorcycle, clutch might start slipping at very high loadIf you stick with recommended dose, then nothing to worry . Bullets could use 100ml dose safely without clutch slipping because bullet clutch springs are having very good tension and engine always works in low rpm . Wet clutch engines could exceed the dose if clutch springs are upgraded to stiffer springs or made stiffer by adding 2mm spacer .

One more thing before you use in engineMake sure to shake it well . The better you shake the more the product will come out of the bottle . If you want to get every last bit from the bottle, use a screw driver or disposed pen to stir the contents at the bottom, this way you won’t have to shake more . Before refilling oil, pour the additive first then pour engine oil into the bottle and shake well . The product is very concentrated and that is why you have to follow this method to get maximum smoothness . use to repeat this process until the oil from the bottle is clear from nanoparticles .Some people won’t even shake and put directly inside engineEven they report engine is really smoothBut in fact they didn’t use 50% of the nano particles inside the bottle .

So you can get maximum smoothness if you follow this little trick